Optical spectrometer
- For Acoustic uses in spectrographs of sound waves, see below.
A spectrometer is an optical instrument used to measure properties of light over a specific portion of the electromagnetic spectrum. The variable measured is most often the light's intensity but could also, for instance, be the polarization state. The independent variable is usually the wavelength of the light, normally expressed as some fraction of a meter, but sometimes expressed as some unit directly proportional to the photon energy, such as wavenumber or electron volts, which has a reciprocal relationship to wavelength. A spectrometer is used in spectroscopy for producing spectral lines and measuring their wavelengths and intensities. Spectrometer is a term that is applied to instruments that operate over a very wide range of wavelengths, from gamma rays and X-rays into the far infrared.
In general, any particular instrument will operate over a small portion of this total range because of the different techniques used to measure different portions of the spectrum. Below optical frequencies (that is, at microwave, radio, and audio frequencies), the spectrum analyzer is a closely related electronic device.
Spectroscopes
Spectrometers are used in spectroscopic analysis to identify materials. Spectroscopes are used often in astronomy and some branches of chemistry. Early spectroscopes were simply a prism with graduations marking wavelengths of light. Modern spectroscopes, such as monochromators, generally use a diffraction grating, a movable slit, and some kind of photodetector, all automated and controlled by a computer. The spectroscope was invented by Gustav Robert Georg Kirchhoff and Robert Wilhelm Bunsen.
When a material is heated to incandescence it emits light that is characteristic of the atomic makeup of the material. Particular light frequencies give rise to sharply defined bands on the scale which can be thought of as fingerprints. For example, the element sodium has a very characteristic double yellow band known as the Sodium D-lines at 588.9950 and 589.5924 nanometers, the colour of which will be familiar to anyone who has seen a low pressure sodium vapor lamp.
In the original spectroscope design in the early 19th century, light entered a slit and a collimating lens transformed the light into a thin beam of parallel rays. The light was then passed through a prism (in hand-held spectroscopes, usually an Amici prism) that refracted the beam into a spectrum because different wavelengths were refracted different amounts due to dispersion. This image was then viewed through a tube with a scale that was transposed upon the spectral image, enabling its direct measurement.
With the development of photographic film, the more accurate spectrograph was created. It was based on the same principle as the spectroscope, but it had a camera in place of the viewing tube. In recent years the electronic circuits built around the photomultiplier tube have replaced the camera, allowing real-time spectrographic analysis with far greater accuracy. Arrays of photosensors are also used in place of film in spectrographic systems. Such spectral analysis, or spectroscopy, has become an important scientific tool for analyzing the composition of unknown material and for studying astronomical phenomena and testing astronomical theories.
Spectrographs
A spectrograph is an instrument that transforms an incoming time-domain waveform into a frequency spectrum, or generally a sequence of such spectra. There are several kinds of machines referred to as spectrographs, depending on the precise nature of the waves.The first spectrographs used photographic paper as the detector. The star spectral classification and discovery of the main sequence, Hubble's law and the Hubble sequence were all made with spectrographs that used photographic paper. The plant pigment phytochrome was discovered using a spectrograph that used living plants as the detector.More recent spectrographs use electronic detectors, such as CCDs which can be used for both visible and UV light. The exact choice of detector depends on the wavelengths of light to be recorded.
The forthcoming James Webb Space Telescope will contain both a near-infrared spectrograph (NIRSpec) and a mid-infrared spectrometer (MIRI).
An Echelle Spectrograph uses two diffraction gratings, rotated 90 degrees with respect to each other and placed close to one another. Therefore an entrance point and not a slit is used and a 2d CCD-chip records the spectrum. Usually one would guess to retrive a spectrum on the diagonal, but when both grating have a wide spacing and one is blazed so that only the first order is visible and the other is blazed that a lot of higher orders are visible, one gets a very fine spectrum nicely folded onto a small common CCD-chip. The small chip also means that the collimating optics need not to be optimized for coma or astigmatism, but the spherical aberration can be set to zero.
Acoustic uses
In acoustics, a spectrograph converts a sound wave into a sound spectrogram. The first acoustic spectrograph was developed during World War II at Bell Telephone Laboratories, and was widely used in speech science, acoustic phonetics and audiology research, before eventually being superseded by digital signal processing techniques.