Jump to content

Tube sound

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Nilmerg (talk | contribs) at 12:25, 18 December 2003 (fixed link). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Valve amplifier is an English expression for what Americans call a tube amplifier.

The valve sound or tube sound refers to the sound often associated with music amplified by a valve amplifier, although this association is not rigourous. The valve sound is often descrived as being "warm", "rich", "relaxed" etc, in contrast to a so-called transistor-sound that is sometimes said to be faster or even "harsh" and "brittle".

In fact this sound has more to do with the circuit topology and circuit design of the amplifier, than to the use of valves rather than transistors as the active gain devices. There is also a degree of influence from the passive components used.

Early amplifiers were by definition valve amplifiers since the transistor did not become common in consumer amplifiers until the late 1960's. The very earliest ampifiers usually had single ended topologies with the most basic type of valve, known as a triode. An audio amplifier using this topology will always be in class A. Class A single ended triode ampliers (Known as "SET"s) have a characteristic distortion spectrum, a simple and monotonically decaying series of harmonics, dominated by modest levels of second harmonic distortion. Second harmonic distortion is musically equivalent to adding the same tone one octave higher, to form a chord. in this case the added tone is at a lower level (typically 5% or less at full power) but the effect is to "fatten" the sound.

Another aspect of the "valve sound" is that early valve amplifiers often had only limited bandwidth, in part due to passive component technology available at the time, notably capacitors. It must be remembered that he source material available at this time (usually vinyl records) lacked the definition of todays CD's. There was no electronic music with extreme bass, and high frequencies mostly contained noise and distortion, so it was advantagous to not emphasise these.

Transistor amplifiers are almost always Class AB push pull, and this topology tends to cancel even order harmic distortion products. The resulting distortion is therefore dominated by odd order harmonics, which to human sensibilities sound "harsh" etc. Transistor amplifiers made during the 1980's typically also had extremely high gain, but poor open loop linearity, and relied on large amounts of negative feedback (NFB). Some consider that NFB does not sound "natural" or "musical", due to errors in the way it reacts to transients. These errors also reveal themselves in very complex distortion spectra, that humans find "discordant".

In contrast audio valves typically have only modest gain, and are extremely linear. This makes it possible to design very simple valve circuits that rely on this inherent open loop linearity and have little, or indeed no, NFB, and thus have very simple distortion spectra.

The subject is further complicated by the way triodes and MOSFETS have certain similarities in their transfer characteristics, whereas later forms of the valve, the tetrode] and pentode have quite different characteristics, in some ways reminicient of the transistor.

All these factors of contribute to the "valve sound" for HiFi applications. Valve amplifiers however are also widely used for electric guitars, in this case for quite different reasons : the way they distort when overdriven is quite different, again leading to a very distinctive sound.

In more modern times, transistor amplifier have become dominant, mainly because they are cheaper to produce, and operate on lower voltages (including batteries, eg applications such as car radio's.) However valve amplifiers have retained a loyal following among hifi fanatics, especially for SET's, in Japan, and in recent years there has also been a resurgence in the west.

Using modern passive components, and modern digital sources and wide band speakers, it is possible to build valve amplifiers that have the characteristic wide bandwidth and "fast" sound of modern transistor amplifiers, including using push pull circuits, class AB and feedback. And some enthusiasts have built amplifiers using transistors and MOSFETS that operate in class A, including single ended, and these often have the "valve sound".